HEWLETT PACKARD (HP) DJ2500CP
Instrukcja Serwisowa

Installation 1. Install the Y axis belt (item 3) onto the carriage assembly making sure the belt is in between the two slider rods (see figure 14, item 5). 2. Install the carriage assembly ' page 8 42 Note: Make sure the Y axis belt is not twisted. 3. Install the Y axis belt (item 3) around the Y axis belt pulley (item 6). 4. Install the Y axis belt pulley with the belt into the Y axis tensioner holder (item 2). 5. Install the belt around the Y axis motor pulley (item 5).

The spring is under high tension and could spring out of the Y axis tensioner holder.
Caution: Cup your hand over the Y axis tensioner holder in the next step to avoid losing the spring. 6. If you have removed the tensioner wedge clip (item 4) and the spring (item 1), install it now. To tension the belt, use a small flat blade screw driver to release the wedge tensioner clip from its position in the Y axis tensioner holder. 7. Install the following: 1. Left Hand Cover ' page 8 18. 2. Right Hand Cover ' page 8 21. 3. Window and Top Cover ' page 8 15. 8. Install the power cable.

WARNING

8-40

HP DesignJet CP Series Printers

Removal and Installation